R&S ESR Series

Remote Control
R&S
®
ESR
777User Manual 1175.7068.02 ─ 12
MMEMory:STORe<n>:LIST <FileName>
This command stores the current list evaluation results in a <file name>.dat file.
The file consists of a data section containing the list evaluation results.
Suffix:
<n>
.
irrelevant
Parameters:
<FileName> <file name>
Example:
MMEM:STOR:LIST 'test'
Stores the current list evaluation results in the test.dat file.
Manual operation: See "Save Evaluation List" on page 264
See "ASCII File Export" on page 264
See "Save Evaluation List" on page 293
See "ASCII File Export" on page 293
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:[IMMediate]
This command starts the list evaluation.
Suffix:
<n>
.
Selects the measurement window.
Example:
CALC:ESP:PSE
Usage: Event
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:AUTO <State>
This command activates or deactivates the list evaluation.
Suffix:
<n>
.
Selects the measurement window.
Parameters:
<State> ON | OFF
*RST: ON
Example:
CALC:ESP:PSE:AUTO OFF
Deactivates the list evaluation.
CALCulate<n>:ESPectrum:PSEarch|:PEAKsearch:MARGin <Margin>
This command sets the margin used for the limit check/peak search.
Suffix:
<n>
.
Selects the measurement window.
Parameters:
<Margin> -200 to 200 dB
*RST: 200 dB
Remote Commands in Spectrum Analyzer Mode