R&S ESR Series

Remote Control
R&S
®
ESR
825User Manual 1175.7068.02 ─ 12
Parameters:
<Offset> Range: -100 GHz to 100 GHz
*RST: 0 Hz
Default unit: Hz
Example:
FREQ:OFFS 1GHZ
Manual operation: See "Frequency Offset" on page 347
[SENSe:]FREQuency:STARt <Frequency>
This command defines the start frequency for measurements in the frequency domain.
Parameters:
<Frequency> 0 to (fmax - min span)
*RST: 0
Example:
FREQ:STAR 20MHz
Manual operation: See "Start" on page 347
[SENSe:]FREQuency:STOP <Frequency>
This command defines the stop frequency for measurements in the frequency domain.
Parameters:
<Frequency> min span to fmax
*RST: fmax
Example:
FREQ:STOP 2000 MHz
Manual operation: See "Stop" on page 347
[SENSe:]FREQuency:SPAN <Span>
This command defines the frequency span.
Parameters:
<Span>
*RST: fmax
Example:
FREQ:SPAN 10MHz
Manual operation: See "IF Span Manual" on page 180
See "Span Manual" on page 350
See "Zero Span" on page 350
[SENSe:]FREQuency:SPAN:FULL
This command sets the frequency span to its maximum.
Example:
FREQ:SPAN:FULL
Manual operation: See "Full Span" on page 180
Remote Commands in Spectrum Analyzer Mode