Remote Control
R&S
®
ESR
832User Manual 1175.7068.02 ─ 12
Parameters:
<Bandwidth> refer to data sheet
*RST: (AUTO is set to ON)
Example:
BAND:VID 10 kHz
Manual operation: See "Video BW Manual" on page 361
[SENSe:]BANDwidth|BWIDth:VIDeo:AUTO <State>
This command couples and decouples the VBW to the RBW.
Use [SENSe:]BANDwidth|BWIDth:VIDeo:RATio to define the ratio VBW/RBW.
Parameters:
<State> ON | OFF
*RST: ON
Example:
BAND:VID:AUTO OFF
Manual operation: See "Video BW Manual" on page 361
See "Video BW Auto" on page 362
See "Default Coupling" on page 365
[SENSe:]BANDwidth|BWIDth:VIDeo:RATio <Ratio>
This command defines the ratio between video bandwidth (Hz) and resolution band-
width (Hz).
Note that the ratio defined with the remote command (VBW/RBW) is reciprocal to that
of the manual operation (RBW/VBW).
Parameters:
<Ratio> Range: 0.01 to 1000
*RST: 3
Example:
BAND:VID:RAT 3
Sets the coupling of video bandwidth to video bandwidth =
3*resolution bandwidth
Manual operation: See "RBW/VBW Sine [1/1]" on page 364
See "RBW/VBW Pulse [.1]" on page 364
See "RBW/VBW Noise [10]" on page 364
See "RBW/VBW Manual" on page 365
See "Span/RBW Auto [100]" on page 365
Remote Commands in Spectrum Analyzer Mode
To Next Page
Loading...
Need help?
General
