R&S ESR Series

Remote Control
R&S
®
ESR
951User Manual 1175.7068.02 ─ 12
*RST: OFF
Example: See "Designing a transducer factor" on page 949.
Manual operation: See "Defining characteristics of a transducer factor"
on page 508
[SENSe:]CORRection:TRANsducer:ACTive?
This command queries the currently active transducer factor.
Parameters:
<TransducerFactor> String containing the name of the transducer factor.
If no transducer factor is active, the string is empty.
Example:
CORR:TRAN:ACT?
Queries the ative transducer factor.
Usage: Query only
[SENSe:]CORRection:TRANsducer:CATalog?
This command queries all transducer factors stored on the R&S ESR.
Parameters:
<FileInformation> String containg the file information.
'<NameFileN>,<SizeFileN>'
<NameFileN>
Name of the file.
<SizeFileN>
Size of the file in bytes.
Return values:
<UsedDiskSpace> Size of all available files containing transducer factors in byte.
<FreeDiskSpace> Remaining disk space in bytes.
Example:
CORR:TRAN:CAT?
would return, e.g.
1579,34482896896,'FACTOR1,823','FACTOR2,756'
Usage: Query only
[SENSe:]CORRection:TRANsducer:COMMent <Comment>
This command defines a comment for a transducer factor.
Before you can use the command, you have to select a transducer factor with
[SENSe:]CORRection:TRANsducer:SELect on page 953.
Parameters:
<Comment> String containing the comment.
*RST: (empty comment)
Using Transducers