OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 726
TRUNK FOR DN1: If set to yes, when the voice mail auto attendant system
answers a call the OfficeServ 7100 system will send data in the DN1 field
indicating that a trunk is ringing the VMAA port.
If set to no, when the voice mail auto attendant system answers a call the
OfficeServ 7100 system will not send trunk data in the DN1 field.
EXTENSION FOR DN2: If set to yes, when the voice mail auto attendant system
answers a call the OfficeServ 7100 system will send data in the DN2 field
indicating the originating station of the call ringing the VMAA port.
If set to no, when the voice mail auto attendant system answers a call the
OfficeServ 7100 system will not send station data in the DN2 field.
TRUNK FOR DN2: If set to yes, when the voice mail auto attendant system
answers a call the OfficeServ 7100 system will send data in the DN2 field
indicating the originating trunk of the call ringing the VMAA port.
If set to no, when the voice mail auto attendant system answers a call the
OfficeServ 7100 system will not send trunk data in the DN2 field.
SEPARATOR: When both DN1 and DN2 are used, a digit defined here is sent
between DN1 and DN2 so the VMAA system can determine where DN 1 stops
and where DN 2 starts. The separator can be DTMF 0 through 9, A, B or C
DISCONNECT: This is the call progress digit sent to the VMAA port in place of a
disconnect open. The digit defined here is sent three times.
CALLER ID NUMBER: If set to yes, when the voice mail auto attendant system
answers a call the OfficeServ 7100 will send Caller ID data as DTMF tones to the
VMAA port.
CALL TYPE ID: This is the DTMF digit that is sent first in the in band digit string
and can identify any of the following call types:
0. DIRECT CALL A call originating directly from another station in
the system.
1. ALL FWD CALL This indicates that a call was forwarded to the
VM/AA port from a station with CALL FORWARD
ALL set.
To Next Page
