OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 MAY 2009
MMC: 837
o PBX MANAGED 2: Use proprietary method.
• 302 RESP: When this option is enabled, OfficeServ will respond to the
“302” SIP message. This is used for call forwarding feature
on ITSP.
• USER TABLE: This option selects the USER TABLE number for use in the
MMC 839.
• DEST TYPE: Specified which value to be referenced to determine the
destination DID number.
• CODEC NEGO: This option enables or disables auto CODEC negotiation for
SIP trunking.
• HOLD RE-INV: When enabled, OfficeServ will send INVITE message to the
ITSP when HOLD key is pressed.
• URI TYPE: Determines the Universal Resource Identifier Type for the
connection. Available options are SIP and TEL.
• SIGNAL TYPE: Determines the TCP/IP protocol to use for this connection.
Available options are UDP and TCP.
• E.164 ENABL: This option determines if the SIP carrier uses the E.164
numbering format or not.
• SIP CARRIER: SIP carrier (ITSP) name
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
ACTION DISPLAY
1. Press TRANSFER 837.
Display shows the first available option. Press
SIP : RE-TRANS T1
05
volume UP or DOWN key to select the option
or press RIGHT soft key to move cursor and
select the option.
To Next Page
