OfficeServ 7100 PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 2007
MMC: 852
ALM
NO.
ALM
CODE
ALARM DEFINITION
50 MJD19 PRI Restart
The PRI card has restarted
Alarm Data = Cabinet, Slot (C1,2) (S1
through 10)
51 MJD20 BRI Restart
The BRI card has restarted
Alarm Data = Cabinet, Slot (C1,2) (S1
through 10)
52 MJD21 PCM Loss
Loss of PCM coding on a digital facility.
Alarm Data = Cabinet, Slot (C1,2) (S1
through 10)
53 MJD22 PCM Recovery
Recovery of PCM coding on a digital
facility.
Alarm Data = Cabinet, Slot (C1,2) (S1
through 10)
54 MJE01 MGI Restart An MGI card has restarted.
55 MJE02 MGI Stop An MGI card has stopped.
56 MJE03 MGI IP Duplicate MGI IP address conflict.
57 MJE04 MGI Ntwk Error
58 MJE05 MGI Ntwk Rec. MGI Recovery.
59 MJE06 MGI DSP Error
60 MJE07 MGI DSP Run
MJE10 SVM Card Restart Card Restarted
MJE11 SVM Card Halt Card Halted
MJE12 SVM Card Down Card When Down
MNF32 SVM Card Ready Alarm Code when voicemail is ready.
MNF33 SVM Card Request
Alarm Code when voicemail request the
number to MCP after restarting.
61 MNF01 Card Out
A circuit card mounted in a universal slot
has been removed from service or is not
recognized by the Common Control
Processor
Alarm Data = Cabinet-Slot (C1,2)-(S 1
through 10)
62 MNF02 Card In
A circuit card mounted in a universal slot
has been returned to service.
Alarm Data = Cabinet-Slot (C1,2)-(S 1
through 10)
63 MNF03 IPC Error
Inter processor communication error
has occurred.
Alarm Data = Cabinet-Slot (C1,2)-(S 1
through 10)
To Next Page
Loading...
