A.16
SEL-351A Relay Instruction Manual Date Code 20080213
Firmware and Manual Versions
Instruction Manual
Section 6
➤ Corrected 79DTL factory default setting (Tabl e 6. 4).
Section 7
➤ Added subsection Details on the Remote Control Switch MOMENTARY Position on page 7.10.
➤ Corrected subsection Relay Disabled Momentarily During Active Setting Group Change on page 7.19.
Section 9
➤ Corrected error in Relay Word bit description for 51G (Table 9.6).
➤ Expanded setting range for 27B81P in Frequency Element (See Figure 3.30–Figure 3.32) on page SET.11.
➤ Corrected FP_TO setting range on Front-Panel Display Operation (only on models with LCD—See Section 11)
on page SET.20.
➤ Added AUTO = DTA setting choice to Port Setting Sheets.
Section 10
➤ Added DTA2 compatibility information.
➤ Added notes about powering down the relay after setting the date or time.
➤ Added note to TA R R command description.
➤ Added details to COP m n command description.
➤ Revised SEL-351A Relay Command Summary
Section 11
➤ Corrected Rotating Default Display on page 11.12 example.
Section 12
➤ Minor change to Overview on page 12.1.
➤ Added cautionary note on SER settings.
Appendix A
➤ Updated Firmware Version information.
Appendix B
➤ Added Step 16 for Breaker Wear Monitor data.
Appendix D
➤ Changes to A5CO Relay Definition Block on page D.3.
➤ Correction to A5E0 Fast Operate Remote Bit Control on page D.10.
➤ Updated ID message.
Appendix E
➤ Corrected CASCII command.
Appendix G
➤ Corrected Figure G.1 and Figure G.2 for rising- and falling-edge operators.
➤ Corrected Ta ble G. 2.
Appendix H
➤ Corrected spelling of DECPLA, DECPLV, and DECPLM settings for DNP.
➤ Corrected index error in Relay Summary Event Data on page H.18.
This manual differs from the previous version as follows:
991123
Appendix H
➤ Corrected documentation errors in Tab le H .4 .
990909
➤ New manual release.
Table A.3 Instruction Manual Revision History (Sheet 10 of 10)
Revision
Date
Summary of Revisions
Courtesy of NationalSwitchgear.com
To Next Page
Loading...