Siemens HiPath 1120 - Backplane; Hipath 1150; Figure 3-36 MDF - Connectors; Figure 3-37 Backplane Hipath 1150

Service Manual
3-101
Modules
Backplane
MDF Interfaces
Figure 3-36 MDF - Connectors
3.10 Backplane
Introduction
In the HiPath1150/1190/1190R systems, a set of Connectors mounted on a printed circuit
board known as the backplane connects the modules to the motherboard.
3.10.1 HiPath 1150
Interfaces
Figure 3-37 Backplane HiPath 1150
Cables are attached
with
screws
Cables are attached using
pressure
(Dinkle Connector)
Cables are attached using
Connectors
4-way
8-way
2-way
(for example, RJ 45)