Siemens HiPath 1120 - Figure 4-29 Installing a CTR- UP0;E Hipath 1150 Module; On the Hipath 1150

Service Manual
4-159
Installation
Installing modules
4.7.9.2 On the HiPath 1150
Installation Procedures
Assembly Diagram
Figure 4-29 Installing a CTR- U
P0/E
HiPath 1150 module
Step Procedure
1. Remove the power supply.
2. Remove the Main Distribution Frame’s cover.
3. Remove the backplane.
4. Remove the slots above the MB.
5. Attach the module to the corresponding Connector on the MB
6. Reassemble the entire set.
7. “Performing a visual inspection” on page 4-189.
8. Turn on the power supply.
9. Configure the required data (see “Operation” on page 7-278).