Siemens HiPath 1120 - Figure 7-38 Windows 98 SE - Selection for ISDN

Operation
7-318 Service Manual
Driver Installation
6. A message will appear informing that optiPoint is being searched for. Repeat hardware
driver installation (steps 1 through 4)
To install administration drivers + CAPI optiPoint Interface, please follow these steps:
7. During installation of optiPoint (CAPI Interface) configure these two settings:
● In the following window, select "EURO-ISDN (DSS1)" and click "Next”:
Figure 7-38 Windows 98 SE - selection for ISDN
● Enter an available extension number in the "Phone # (MSN)" field (for HiPath 1120/1150
the valid extension range X-Y). Click "Next" to confirm. The same will appear again. Click
"Next" one more time without entering anything in any field: