Operation
7-290 Service Manual
System programming mode using a PC
7.2.2 Remote / Local connection
7.2.2.1 External Analog modem
For this option, the HiPath 1100 applications are installed. After restarting the computer
configure the settings on CommServer, HiPath 1100 Manager and the HiPath 1100 system.
Procedure:
1. Connect the analog modem (to connect the modem’s extension, see item 4.7 - Connecting
extensions to the system’s internal MDF) as follows:
Figure 7-8 External analog modem connection
2. Insert the HiPath 1100 CD in the CD drive
If Auto-Run is not configured, go to the Windows Start menu, click Run and then select the
Browse button in the dialog box. Open the SETUP.EXE file on the CD drive.
3. In the Setup window, select the language you want to use
4. A window will appear where you can select the software to be installed
5. Install your selected software components sequentially. For programming the HiPath 1100
system, the following applications must be installed:
● HiPath 1100 Manager and
● CommServer (installs automatically).
6. After each component is installed, a message is displayed indicating that the installation
was completed successfully. Click "Next" every time it appears
HiPath 1100
ANALOG MODEM
EXTERNAL LINE
Extension
of the
Serial
Cable
Public Network
Manager
Billing
Software
Status Monitor
Transmission
CommServer
HiPath 1100 Applications
ANALOG MODEM
EXTERNAL or INTERNAL LINE
REMOTE
ADMINISTRATION
LOCATION
HiPath 1100
ADMINISTERED
To Next Page
Loading...
