Operation
7-302 Service Manual
Driver Installation
Figure 7-20 Windows ME - USB/CAPI installation location.
5. A message will appear informing that a driver has been found. Click "Next" to proceed.
6. The installation of the USB drivers will be confirmed. Click "Finish."
7. A message will appear informing that HiPath 1000is being searched for. Repeat driver
installation procedures for USB interface devices (Steps 1 to 6)
To install administration + CAPI Interface drivers, follow these steps:
8. A message will appear indicating that the best driver for the hardware has been found.
Click "Next" to proceed.
To Next Page
Loading...
Need help?
General