Service Manual
7-279
Operation
Programming with a Telephone Set
7.1 Programming with a Telephone Set
System programming can only be executed using the first slot on an analog extension of
the interface (default extension 11) equipped with an analogextension (MF) or on a KS-type
system telephone or in the first slot of an optiPoint 500-type system telephone. Programming
cannot be made on two extensions at the same time.
The reason for initially using a KS-type system telephone at extension slot 11/101 is that the
systems are shipped from the factory with the following default settings:
● A1 and B1 slots are assigned to C1 and D1 slots on the motherboard (see “Connections
to the system’s MDF” on page 4-170).
When using a system telephone with a display, you can follow the programming steps visually
on the display.
Programming mode syntax
All the programming is done by entering a code then a setting.
Each additional setting entered is followed by a confirmation tone (1 beep). If the parameter is
keyed in wrong, it is followed by 3 beeping tones after which the system returns to its initial
programming state.
There are three different ways to finalize the configuration of a setting and return
to the initial state of the programming mode:
● Programming concludes automatically after settings are entered
● Pressing the # key after entering the setting
● Waiting 5 seconds after entering the setting.
If no code or setting is entered, the system will continue to wait for data input or will assume
that a "null entry" occurred. It will proceed to the next programming step according to the code
first entered.
After a setting is programmed, the display will return to the initial state of the programming
mode. To exit programming mode, simply replace the handset.
To access the programming mode on the specified extensions:
● Programming extension: *95 + PASSWORD (default: 31994).
To Next Page
Loading...
