Siemens HiPath 1120 - Figure 7-59 ADSL Router Configuration SW

Operation
7-338 Service Manual
HiPath 1100 applications
Figure 7-59 ADSL router configuration SW
Checking the version of the ADSL SW
To check which version of the SW is loaded in the ADSL module, please proceed as follows:
1. Connect a PC to the Module;
2. Open a command prompt in Windows (DOS prompt);
3. Run this command: telnet X.X.X.X (where X.X.X.X is the IP address configured in the
ADSL module, in this case 10.0.0.1);