Operation
7-296 Service Manual
Driver Installation
7.3.1.1 Installation Setup
1. Make sure the HiPath 1100 system is turned on (do not connect the USB cable at this point.
This should be done during driver installation)
2. Insert the HiPath 1100 CD in the PC’s CD drive
3. Select USB Drivers option
Figure 7-13 Installation Setup - USB Drivers
4. Select the type of driver to install
Administrator access is required for performing the installation under Windows
2000/XP.
If other PABX drivers or an ISDN card are already installed on the system, they must
be completely uninstalled before installing any other driver.
To Next Page
Loading...
