Siemens HiPath 1120 - Figure 4-28 Installing a CTR- UP0;E Hipath 1120 Module; Installing a CTR- UP0;E Module; On the Hipath 1120

Installation
4-158 Service Manual
Installing modules
4.7.9 Installing a CTR- U
P0/E
module
4.7.9.1 On the HiPath 1120
Installation Procedures
Assembly Diagram
Figure 4-28 Installing a CTR- U
P0/E
HiPath 1120 module
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Attach the module to the corresponding Connector on the MB
4. Reassemble the entire set.
5. “Performing a visual inspection” on page 4-189.
6. Turn on the power supply.
7. Configure the required data (see “Operation” on page 7-278).