Siemens HiPath 1120 - Figure 4-25 Installing an EVM Module Hipath 1150; On the Hipath 1190;1190 R

Service Manual
4-155
Installation
Installing modules
Assembly Diagram
Figure 4-25 Installing an EVM module HiPath 1150
4.7.7.3 On the HiPath 1190/1190R
Installation Procedures
Step Procedure
1. Turn off the power supply.
2. Remove the system’s front cover.
3. Disconnect the Main Distribution Frame’s cables from the MB.
4. Move the module’s latch as shown in figure 4-12.
5. Remove the MB.
6. Attach the separator provided with the EVM module to the MB.
7. Attach the module to the MB’s pin Connector and to the separator.
8. Insert the MB into the system.
9. Move the module latch back to secure module.
10. Connect the Main Distribution Frame’s cables.