Siemens HiPath 1120 - Figure 7-63 Changing the Default IP Address

Service Manual
7-341
Operation
HiPath 1100 applications
Changing the IP address
Change the IP address using the link : >>Network<< - >>LAN<<.
Figure 7-63 Changing the default IP address
When you have changed the IP address, NetMask and Gateway, press >>Change<< to
confirm the changes. This configuration will be saved once you press Save & Reboot.
After rebooting, you will not be able to access the “Siemens administrative Con-
sole” for 30 seconds and the new IP address must be inserted into the web browser
to access the web interface.