Service Manual
4-161
Installation
Installing modules
4.7.10 Installing a Music module
4.7.10.1 On the HiPath 1120
Installation Procedures
Assembly Diagram
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Raise the system’s top slot (MB).
4. Insert the module in the slot shown on figure 4-31.
5. Attach the MB to the module.
6. Make the connections to the appropriate module Connector (See “Music module”
on page 3-91).
7. Reassemble the entire set.
8. “Performing a visual inspection” on page 4-189.
9. Turn on the power supply.
10. Configure the required data (see “Operation” on page 7-278).
To Next Page
Loading...
