Siemens HiPath 1120 - International Safety Standard; Environmental Conditions; Table 2-12 Environmental Conditions

System Data
2-40 Service Manual
Technical standards and compliance
2.7.1 International Safety Standard
● IEC 60950
2.7.2 Environmental conditions
Table 2-12 Environmental conditions
Servicing conditions (mechanical)
● This system was essentially designed for installation at a fixed location.
Operation Transportation Storage
Air Temperature (the
F
) +41 to +86 -13 to +158 41 to +113
Relative humidity 5% to 85 % 95% 5% to 95%
Warning
● Tthe avoid condensation when shipping the system in extremely low
temperatures, keep the equipment in its packaging until it reaches room
temperature. Proceed thereafter with the installation (acceptable temperature
range: 7.5•C (45.5•F)/30 min)
● Do not expose the equipment to direct sunlight or place it near any heat sources
(to avoid a localized increase of temperature)
● Make sure the installation area is dry. During system operation avoid any
conditions that may cause condensation.
● Forced ventilation is not required.
● Do not block the natural flow of air around the equipment.
● Do not expose the equipment to the weather.
!