Service Manual
7-301
Operation
Driver Installation
Windows ME
1. Connect the HiPath 1100 system to the computer
2. The Add New Hardware wizard will appear. A message will appear indicating that Setup
will search for new Composite USB device drivers. Click "Next" to proceed.
3. Choose "Specify the location of the driver (Advanced)" and click "Next." Click "Next" to
proceed.
Figure 7-19 Windows ME - Specify installation folder.
4. Select the “Search for the best CAPI for your device (Recommended)” checkbox then
select the “Specify a location” checkbox. Under Browse, select the directory where the
decompressed driver is stored. Drivers can be found in the \Software\USB Drivers folder
of the CD. The driver is decompressed in C:\Temp (Default). If the Administration driver is
selected, the directory path will be C:\Temp\HiPath1100_Adm_Drivers_040. If you select
the Administration + CAPI Interface, the directory path will be
C:TempHiPath1100_AdmCAPI_ Drivers_040. Select a folder and click "Next"
To Next Page
Loading...
