Siemens HiPath 1120 - Installing the Power Supply; Figure 4-32 Installing a Power Supply on the Hipath 1120; On the Hipath 1120

Service Manual
4-163
Installation
Installing the power supply
4.8 Installing the power supply
Introduction
4.8.1 On the HiPath 1120
Installation Procedures
Figure 4-32 Installing a power supply on the HiPath 1120
Before connecting the power supply to the system, see “Technical Data” on page 2-
38 “ and “Power Supply Unit (PSU)” on page 3-93.
Step Procedure
1. Check network voltage
2. If the voltage is within the power supply’s voltage range, connect the power supply.
3. “Performing a visual inspection” on page 4-189
4. Configure the required data (see “Operation” on page 7-278).
Warning
Use the cable of the power supply to turn system power on or off.
!