Siemens HiPath 1120 - Figure 4-23 Installation Module Baby Board ADSL on the Hipath1150;1190;1190 R; Installing an EVM Module; On the Hipath 1120

Service Manual
4-153
Installation
Installing modules
Assembly Diagram
Figure 4-23 Installation module Baby Board ADSL on the HiPath1150/1190/1190R
4.7.7 Installing an EVM module
4.7.7.1 On the HiPath 1120
Installation Procedures
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Attach the separator provided with the module to the MB.
4. Attach the module to the MB’s pin Connector and to the separator.
5. Reassemble the entire set.
6. “Performing a visual inspection” on page 4-189.
7. Turn on the power supply.
8. Configure the required data (see “Operation” on page 7-278).
X7
X6
X14
X7
X6
X14