Operation
7-284 Service Manual
System programming mode using a PC
4. Select the software components you wish to install and install them. For programming the
HiPath 1100 system, the following applications must be installed:
● HiPath 1100 Manager
● CommServer (installs automatically).
5. After each component is installed, a message is displayed indicating that the installation
was completed successfully. Click "Next" every time it appears
6. Click "Finish" to close the installation window. This completes the software installation.
Windows may display a message to restart the computer. If this occurs, restart the
computer.
7. After installation is completed, configure the Communication Server (see Figure 7-3).
Right-click the CommServer icon on the Windows status bar and select "Properties":
Figure 7-3 Communication Server Properties - Configuring a USB Connection
8. The CommServer will be dialed automatically when an application is enabledHiPath 1100.
To Next Page
Loading...
