Siemens HiPath 1120 - Figure 4-13 Installing the Hipath 1190 R on a 19 Rack

Installation
4-136 Service Manual
Getting to know your systems
module installation procedure
Installation on a 19" Rack
Figure 4-13 Installing the HiPath 1190R on a 19" rack
Rack-Mounting Procedure
Step Procedure
1. Insert module into the appropriate slot.
2. Move the latch to the right to secure each module in place.
3. Secure each latch using the screws.
4. Use the reverse procedure to remove the modules.
Step Procedure
1. Install the system’s brackets on the 19" rack using the screws as shown.
2. Insert the switch into the 19" rack.
3. Secure the switch on the 19" rack using the screws.