Service Manual
4-137
Installation
HiPath1120/1150 wall mounting instructions
4.6 HiPath1120/1150 wall mounting instructions
Back of the enclosures
Figure 4-14 Installing the HiPath 1120
Step Procedure
1. Drill a hole in the wall at a height of 4.10 ft from the floor.
2. Place the bushing over the hole then insert the screw and tighten it until only 0.19"
protrude.
3. Hang the system at the top of ➀, on the screw (see figure 4-14 and figure 4-15).
4. Mark additional holes for washers ➁ and remove the system.
5. Drill the remaining holes as marked, install washers and screws then tighten them
letting 0.19" protrude.
6. Hang the system again and align it by tightening the lower screws.
To Next Page
Loading...
