Service Manual
7-307
Operation
Driver Installation
11. The installation of the USB drivers is now complete. CAPI applications installation will now
start automatically (see “CAPI Application setup” on page 7-313).
Windows 2003
Proceed as follows:
1. Connect the HiPath 1100 system to the computer using a USB cable
2. The Found New Hardware Wizard window will appear so that new drivers can be installed.
Choose "Install from a list or specific location (Advanced)" Click "Next" to proceed.
Figure 7-28 Windows 2003 - Driver location
3. A second window will open. Select “Search for the best CAPI in these locations” then select
“Include this location in the search”. Under Browse, select the directory where the
decompressed driver is stored. Drivers can be found in the \Software\USB Drivers folder
of the CD. The driver is decompressed in C:\Temp (Default). If the Administration driver is
selected, the directory path will be C:\Temp\HiPath1100_Adm_Drivers_040. If you select
the Administration + CAPI Interface, the directory path will be
C:TempHiPath1100_AdmCAPI_ Drivers_040. Select a folder and click "Next"
You must have administrator’s access privileges to install any software
To Next Page
Loading...
