Siemens HiPath 1120 - (Voltage Conditioner Circuitry); Figure 4-27 Installing a Baby Board VCC Module on the Hipath 1120; Installing a Baby Board VCC Module; On the Hipath 1120

Service Manual
4-157
Installation
Installing modules
4.7.8 Installing a Baby Board VCC module
(Voltage Conditioner Circuitry)
4.7.8.1 On the HiPath 1120
Installation Procedures
Assembly Diagram
Figure 4-27 Installing a Baby Board VCC module on the HiPath 1120
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Attach the separator provided with the module to the MB.
4. Attach the module to the MB’s pin Connector and to the separator.
5. Reassemble the entire set.
6. “Performing a visual inspection” on page 4-189.
7. Turn on the power supply.
8. Configure the required data (see “Operation” on page 7-278).