Siemens HiPath 1120 - Table 2-10 Technical Data; Technical Standards and Compliance

Service Manual
2-39
System Data
Technical standards and compliance
*〉 Values vary according to the country. The values shown are specifically for Brazil.
**〉 Values depend on the country settings, which are configurable. The values shown are default values for Brazil.
Table 2-10 Technical Data
2.7 Technical standards and compliance
*〉 Weather conditions: Operation 3K3 Transportation 2K4 Storage 1K3.
Mechanical: Operation 3M3 Transportation 2M2 Storage 1M2.
Table 2-11 Standards and compliance
Open loop isolation
resistance between A/B or a/
ground or b/ground
> 10MΩ
Closed loop line resistance/
continuous loop current
Complies with national requirements/standards
Incoming Call Detection > 9V
RMS
Values shown are approximate. When making connections, consider the specific
level of tolerance that applies.
Compliance Standard Note
Electrical Safety
EN60950
IEC 60950
UL 60950-1
Environmental Conditions IEC 721 *
Power Surge
IEC61000-4-5
(IEC 801-5)
TIA-968-A
Level 3
Fast Transients
IEC61000-4-4
(IEC 801-4)
Level 3
Static electricity discharge
IEC61000-4-2
(IEC 801-2)
Air - Level 3 (8kV)
Contact - Level 2 (4kV)
Element HiPath 1120 HiPath 1150 HiPath 1190