Siemens HiPath 1120 - Configuring the Speed Stream Modem; Figure 7-66 Firmware Upgrade

Operation
7-344 Service Manual
HiPath 1100 applications
Once you have selected the file with the correct version of firmware, proceed upgrading by
pressing >>Upgrade<<.
Figure 7-66 Firmware Upgrade
The operation is complete when the word done appears on the web page.
7.4.4.3 Configuring the Speed Stream Modem
Once you have installed the ADSL access to you provider and the connections to HiPath 1100,
you may need to adjust the parameters of the SADSLIM (HiPath 1120) and ADSLIM
(HiPath1150/1190/1190R) modules of the ADSL modem.
You can also access the Speed Stream Modem configuration using the web interface. The
default IP address is 192.168.254.254 and can be accessed from any web browser, such as
MS Internet Explorer.
Updating the firmware returns the module to the default factory configuration. This
will reboot the module and you will not be able to access the “Siemens administra-
tive Console” for 30 seconds and the default IP address (192.168.254.253) must be
inserted into the web browser to access the web interface