Operation
7-286 Service Manual
System programming mode using a PC
Figure 7-4 Properties of the CommServer - Connections ADSL module
8. SLIMC, SADSLIM, LIMC or ADSLIM modules - On the HiPath 1100 V7.0, you do not
need to use the CommServer installed in your machine, as these modules already have a
CommServer installed, known as eCommServer. You may therefore make an authorized
LAN access to the PABX of an external application such as those that use the SNMP
platform.
Configure the IP address and Port of the LAN interface module in the HiPath 1100 Manager
in Tools/CommServe Configuration. menu
Defaults:
– Port:3100
– Default IP of the module: 192.168.254.253
9. When a HiPath 1100 application is activated, the server starts automatically.
The V.24 Serial Interface may not be used if a LAN interface module is installed in
the PABX.
To Next Page
Loading...
