Siemens HiPath 1120 - Figure 7-11 ISDN Configuration Options

Operation
7-294 Service Manual
System programming mode using a PC
Figure 7-11 ISDN Configuration options
Procedure:
1. Check that the HiPath 1100 system is ON
2. Insert the system CD in the CD drive.
If Auto-Run is not configured, go to the Windows Start menu, click Run and then select the
Browse button in the dialog box. Open the SETUP.EXE file on the CD drive.
3. In the Setup window, select the language you want to use
4. A window will appear where you can select the software to be installed
5. Install your selected software components sequentially. For programming the HiPath 1100
system, the following applications must be installed:
● HiPath 1100 Manager and
● CommServer (installs automatically).
6. After each component is installed, a message is displayed indicating that the installation
was completed successfully. Click "Next" every time it appears
7. Select “Close“ to close the installation window. Installation is then completed and the
computer has to be restarted.
CAPI
driver
Manager
Billing
Software
Status Monitor
Transmission
ISDN
Card
CommServer
HiPath
1100
S
0
ext
S
0
inte
HiPath 1100 Applications
S
0
Trunk
CAPI
driver
Manager
Billing
Software
Status Monitor
Transmission
ISDN
Card
CommServer
HiPath 1100 Applications
NTBA
S
0
BUS
OR