Siemens HiPath 1120 - Figure 7-1 Communication Server Properties - Configuring a V.24 Serial Interface

Operation
7-282 Service Manual
System programming mode using a PC
8. After installation is completed, configure the Communication Server (see Figure 7-1).
Right-click the CommServer icon on the Windows status bar and select Properties. Specify
these settings:
● Connection Type
● Baud Rate 19200 (Default) / 38400 / 57600 / 115200 baud
● COM port
Figure 7-1 Communication Server Properties - Configuring a V.24 Serial Interface
9. The CommServer will be dialed automatically when an application is enabledHiPath 1100.
The V.24 Serial Interface may not be used if a LAN interface module is installed in
the PABX.