Service Manual
7-331
Operation
Driver Installation
7. The installation of the USB drivers will be confirmed. Click "Finish."
8. A message will appear that HiPath 1000 drivers are being searched for. Repeat driver
installation procedures for USB interface devices (Steps 1 to 3)
9. Click "Next" to proceed.
10. A message will appear twice to the effect that the driver does not have a Windows logo.
Click "Continue" every time this message will appear.
11. The installation of the USB drivers is now complete. CAPI applications installation will now
start automatically (see “CAPI Application setup” on page 7-331).
7.3.2.3 CAPI Application setup
CAPI application driver installation is very simple and is the same for all Windows operating
systems.
Upon conclusion of USB driver installation, the CAPI applications installation window will
appear. Proceed as follows:
1. In this window, select the language you want to use and click "OK" to confirm.
2. When you see the Welcome screen, click "Next" to proceed. The installation window will
then display the (default) path for installation of the CAPI applications (CallBridge for Data
Utilities). You can choose a different path by selecting "Browse." Click "Next" to proceed.
3. In the following window, create a new program folder or choose an existing folder in which
to store program icons for running the corresponding applications.
4. To complete the installation process, answer the introductory messages by clicking "Next"
Click "Finish" to close the installation window.
The following applications are then installed on your computer:
● ISDN Setup Wizard (Windows 98 SE/ME)
● CAPI Monitor
● Uninstaller
● FaxComm + Installation
● Loopback Test
● Outgoing Numbers Configuration (MSN) (Windows 2000/XP)
.
Restart the computer after installation of USB drivers and CAPI applications.
To Next Page
Loading...
