Siemens HiPath 1120 - Installing a USB Interface; Figure 4-42 Illustration of USB Cable Connection; On the Hipath1120;1150

Installation
4-178 Service Manual
Installing a USB Interface
4.11 Installing a USB Interface
Introduction
To connect a PC to the HiPath 1100 using a USB interface you must have a USB adapter cable
(see “USB adapter cable” on page 3-116). This interface allows you to use certain applications
developed specifically for configuring and managing user features.
4.11.1 On the HiPath1120/1150
Figure 4-42 Illustration of USB cable connection
Connections
Warning
The installation drivers are on the Setup and Installation CD.
Step Procedure
1. Plug the USB adapter cable (with the male Mini DIN Connector) into the 4-pin Mini
DIN Connector on the motherboard (Figure 4-42).
2. Connect the A to B Standard end of the USB cable to the USB adapter, and connect
the other end to the computer or modem.
!