Siemens HiPath 1120 - Figure 7-16 Windows 98 SE - USB Drivers Installation Location

Service Manual
7-299
Operation
Driver Installation
Figure 7-16 Windows 98 SE - USB drivers installation location
5. A message will appear informing that a driver has been found. Click "Next" to proceed.
6. The installation of the USB drivers will be confirmed. Click “Finish”
7. A message will appear informing that HiPath 1000is being searched for. Repeat driver
installation procedures for USB interface devices (Steps 1 to 4).
To install administration + CAPI Interface drivers, follow these steps:
8. During installation of the HiPath 1000 (CAPI Interface) configure these two settings:
9. In the following window, select "EURO-ISDN (DSS1)" and click "Next":