Siemens HiPath 1120 - Figure 4-19 Installing a TME1 Module; Installing a TME1 Module

Installation
4-148 Service Manual
Installing modules
4.7.4 Installing a TME1 module
Assembly Diagram on the HiPath1150/1190/1190R
Figure 4-19 Installing a TME1 module
Warning
Do not touch the administration serial interface Connector of the TME1 module be-
fore disconnecting all analog extensions and external line Connectors. Failure to fol-
low this procedure may expose the user to dangerous voltages. The TME1 module
interconnecting cables and Connectors should only be handled by qualified technical
personnel.
Remember to set the DIP switches (See “TME1 module” on page 3-69).
!