Operation
7-350 Service Manual
HiPath 1100 applications
Figure 7-73 Communication Server Configurations
After configuring the IP of the the ADSL module, the application can connect directly to the
eCommServer installed in the module.
7.4.4.7 How to release the ADSL feature in new Countries
1. Send the current settings used for ADSL and also test the same settings in the Module. As
soon as this information, indicating the correct function, is received by the area responsible
(renato.collere@siemens.com, harold.erbesdobler @siemens.com and
sergio.gamo@siemens.com), it will be included in the official release documentation of the
ADSL (also stored in the KMOSS) where countries, carriers and configurations are listed.
2. The following sequence will be included in the official release documentation of the ADSL:
1. Do the following if the ADSL is being introduced into a country:
● Check whether there is already official documentation in the KMOSS with the
country and carrier configuration;
● If such documentation exists, it will be tested and released to the local carrier.
– If this configuration is appropriate or if you encounter any problems, inform and
send the details (use the Default form) for the person in charge mentioned above,
who will take any necessary steps (for example, including this in the official
documentation or correcting the problem).
● If there is no configuration for your country or carrier in the official documentation
of the ADSL, please proceed as follows:
– If you are involved in a field test, contact the person in charge and send the
configuration information (use the Default form ), and the necessary steps will be
taken.
To Next Page
Loading...
