Operation
7-278 Service Manual
7Operation
This chapter describes the procedures for powering up and initializing the systems.
Connecting the system to the power supply
Procedure
Activating System Programming
The system HiPath 1100 comes with a factory default configuration, described in the
programming tables for each code.
If an update or modification is required, there are two possible programming options:
Warning
Powering up and initializing the system is a task that must be performed only by au-
thorized technical personnel.
Step Action (Instructions)
1. Connecting the system to the power supply
(Connecting the Power Cable ->Initialization of the interface).
7-278
2. Activating System Programming 7-278
3. Programming with a Telephone Set 7-279
4. System programming mode using a PC 7-280
5. HiPath 1100 applications 7-333
Step Procedure
1. Complete installation of all modules and system (Chapter 4, “Installation”).
2. Connect the interface.
3. Wait a few moments for the system to load the software.
Programming Options Page
Using a system telephone or a Standard MF telephone 7-279
Using a computer 7-280
!
To Next Page
Loading...
