Siemens HiPath 1120 - Figure 4-43 Illustration of USB Cable Connection on Hipath 1190; On the Hipath 1190;1190 R

Service Manual
4-179
Installation
Installing a USB Interface
4.11.2 On the HiPath 1190/1190R
Figure 4-43 Illustration of USB cable connection on HiPath 1190
Connections
3. See System Programming Mode in the “System programming mode using a PC” on
page 7-280.
Step Procedure
1. Plug the USB adapter cable (with the male Mini DIN Connector) into the 4-pin Mini
DIN Connector on the motherboard (Figure 4-43).
2. Connect the A to B Standard end of the USB cable to the USB adapter, and connect
the other end to the computer or modem.
3. See System Programming Mode in the “System programming mode using a PC” on
page 7-280.
Step Procedure