Installation
4-126 Service Manual
Installation Procedures
4.2 Installation Procedures
Table 4-1 HiPath 1100 - Equipment installation procedures
Warning
â—Ź Before installing the equipment, please read carefully all information and
recommendations provided in Chapter 1, “Important Information”
â—Ź When connecting to live terminal equipment lines powered by an external AC
power source, the maximum number of terminal equipment allowed is 14 per
system. Exceeding this limit may damage the equipment and put user safety at
risk.
â—Ź Check whether all AC and DC connections of the cables, modules and chassis
of the HiPath 1100 are correctly and properly connected before connecting the
client interface.
Step Installation procedures (Information)
1. “Select the location for installing the equipment”
(Usually already defined)
4-127
2. “Unpacking system components” 4-128
3. “Getting to know your systems” 4-128
4. “HiPath1120/1150 wall mounting instructions” 4-137
5. “Installing modules” 4-138
6. “Installing the power supply” 4-163
7. “Connections to the system’s MDF” 4-170
8. “Installing a V.24 Interface” 4-177
9. “Installing a USB Interface” 4-178
10. “Installing an external Audio Source” 4-180
11. “Installing a TFE - entrance telephone interface” 4-180
12. “Recommendations concerning the Power Supply and Protection of the
System”
4-182
13. “Protective power outage relays” 4-185
14. “System cabling” 4-186
15. “Installing telephone terminals” 4-186
16. “Performing a visual inspection” 4-189
!
To Next Page
Loading...
