Siemens HiPath 1120 - Figure 3-26 SLIMC and SDASLIM Module Hipath 1120; SLIMC, SADSLIM, LIMC and ADSLIM Modules

Modules
3-84 Service Manual
Optional modules (MO)
3.6.1.2 SLIMC, SADSLIM, LIMC and ADSLIM modules
In this version we have the set comprising a LIM module (LAN Interface Module) and the ADSL
modem (Baby Board ADSL) which can be optionally mounted on the board.
● HiPath 1120 : SLIMC module (LAN) and SADSLIM module (LAN + ADSL modem)
● HiPath1150/1190/1190R : LIMC module (LAN) and ADSLIM module (LAN + ADSL
modem)
Notes:
These modules already have the CommServer application installed and do not need to be
connected directly to a PC to administer the PABX, only to the LAN.
To set the required parameters of the modules, use the “Configuring the SpeedStream
4100 modem” on page 7-354 and the administration tool “Siemens Admin Console” on
page 7-352.
HiPath 1120
Interfaces
SLIMC and SADSLIM module:
Figure 3-26 SLIMC and SDASLIM module HiPath 1120
The ADSL modem used is the Siemens SpeedStream 4100. You can consult the
configuration instructions in the manual which you will find in the Setup and
Installation CD.