Siemens HiPath 1120 - 6 Configuring the System Specifically for the Client; Numbering Plan; Table 6-1 Configuration Procedure Summary; Table 6-2 Detection Sequence of the Modules

Service Manual
6-205
Configuring the system specifically for the client
Numbering Plan
6 Configuring the system specifically for the client
Procedure Summary
Table 6-1 Configuration procedure summary
6.1 Numbering Plan
The Numbering Plan is configured based on the modules detected by the system.
Table 6-2 Detection sequence of the modules
Step System Telephone/Standard MF Telephone HiPath 1100 Manager
1. System programming can only be executed using the
system’s first extension slot (analog extension (MF) or
system telephone).
Connect the PC to the
system.
2. Programming Mode: *95 + PASSWORD (default: 31994). Configure CommServer.
3. Valid parameter or code: beep (Brazil). Start the program.
4. When an incorrect setting is entered: 3 beeps (Brazil). System data are
automatically imported.
5. When completed: 1 beep (Brazil). Start programming.
6. End programming: press “#” key or replace handset. Export the new
configuration settings.
Detection HiPath 1120 HiPath 1150 HiPath 1190
1. Motherboard TME1 module 1 Analog modules
2. S
0
module Motherboard TME1 module 1
3. Analog modules S
0
module S
0
module
4. Analog modules