Service Manual
7-283
Operation
System programming mode using a PC
7.2.1.2 USB Interface
In this case there are two possibilities: USB Interface or USB Interface + CAPI Interface.
Figure 7-2 Possible USB Configurations
In order to perform HiPath 1100 administration using a computer and a USB interface, you
must install the proper CallBridge for Data USB drivers specific for the HiPath 1100 family. This
allows the computer to communicate with the system. This task must be complete before
installing the HiPath 1100 applications.
Install the required drivers (see Chapter 7, “HiPath 1100 USB Drivers” ) then start installing the
HiPath 1100 applications:
Procedure:
1. Insert the HiPath 1100 CD in the CD drive
If Auto-Run is not configured, go to the Windows Start menu, click Run and then select the
Browse button in the dialog box. Open the SETUP.EXE file on the CD drive.
2. In the Setup window, select the language you want to use.
Once the language has been selected, all corresponding country-specific settings will be
established.
3. A window will appear where you can select the software to be installed
Manager
Billing
Software
Status Monitor
Transmission
CommServer
HiPath 1100 Applications
CallBridge
for Data
Possible USB
Configurations
USB
USB
HiPath
1100
To Next Page
Loading...
