Configuring the system specifically for the client
6-260 Service Manual
Comments about the system’s programming codes
Activating a SW Update (055)
This feature allows you to update the system’s software automatically on a scheduled date.
Day for Update (054)
This setting specifies a day for starting the data transfer (upload process).
Time for Software Update (058)
This setting specifies the time of day for starting the data transfer on the specified day.
External number for updating the software (056)
This setting specifies a number to be used by the system to update the software.
Frequency of SW update (057)
This setting specifies regular intervals in months for transferring data.
During transfer the telephone operates as usual.
The default setting specifies updates to be done in a monthly basis.
Uploading the SW Update (059)
This setting specifies when the data downloaded will be uploaded to the system’s memory.
During the upload (approximately 3 minutes) the telephone operates as usual.
The default setting specifies the time for the update process at 00:00 hours.
6.3.7 Remote configuration
Service Call (*994)
This feature allows you to call a service center and let administration be carried out remotely through the on-going call.
Remote Software Update (*9415)
If authorized, a software update can be started automatically.
Remote operation mode (084)
This specifies the remote updating of the software.
An update can be carried out remotely over external digital ISDN lines and analog lines via modem.
Remote administration activation (066)
This setting allows the system to be administered remotely.
To Next Page
Loading...
Need help?
General