Service Manual
4-125
Installation
HiPath 1100 Installation
4Installation
4.1 HiPath 1100 Installation
About this Chapter
This chapter contains information on:
● Installing the interface HiPath 1100. More information on additional equipment and
expansions can be found in the “List of modules” on page 3-44
● Configuration (installation of modules).
Tools and equipment required
The following tools are required for installing a HiPath 1100 system:
– Cutters and flat nose pliers
– Standard screwdriver
– Phillips screwdriver
– Tool for attaching wires to the Main Distribution Frame
– Drill
– Hammer
–Level
– Tape measure
– Digital multimeter for checking power and ground connections.
Danger
Only authorized technical personnel should install this system.
!
To Next Page
Loading...
