Configuring the system specifically for the client
6-264 Service Manual
Comments about the system’s programming codes
● Do not use a Serial or ADSL connection type while using HyperTerminal. During
ticketing the administration can be performed via USB connection, optiPoint, ISDN or
analog modem.
● Tickets will only be shown after the end of the first connection.
● To establish a serial or ADSL connection to the HiPath 1100 Manager, disconnect
HyperTerminal.
The following information is recorded:
● Current date (Date)
● End of call (Time)
● External line used (Ln)
Note: Example of the (Ln) field content for ticketing:
● Extension (Ext)
Some specific types of access will be displayed in this field, indicated by the following numbers:
● COS Changeover (WCOS)
● Ring duration (Ring)
● Call duration (Duration)
It is recommended that you uncheck the "Serial Printing" checkbox on the HiPath
1100 Manager if tickets are not being issued over an ADSL connection.
To provide accurate call details, you must update the system’s time and date infor-
mation.
External line (Ln) Field
801 00
802 01
Access (Ext) Field
Sensor - Outgoing call 9101
Data Link - Outgoing or incoming data call for system administration 9201
DISA - Incoming call 9301
Fax/DID - Incoming call 9401
To Next Page
Loading...
