Siemens HiPath 1120 - Page 353

Service Manual
7-353
Operation
HiPath 1100 applications
– Default IP of the module: 192.168.254.253
– Default Subnet Mask of the module: 255.255.255.0
– Default Gateway of the module: 192.168.254.254
– Default User - admin
– Password - 31994
Info Tab
Shows general information on the module.
Status Tab
Shows information on the status of the connections:
● LAN configuration
● Available physical connections
● Connections of the ADSL modem.
System Tab
Shows information on the interface:
● Password change - changes the access password
● Firmware Upgrade - updates the firmware, with an option to select the "Erase JFFS2
partition" checkbox if you wish to delete the previous settings of the module when you
update.
Network Tab
Shows information on the internal configuration of the module.
● LAN - shows the current configuration and allows you to change parameters (IP address,
Netmask, Gateway and DHCP Client number).
● Hosts - shows the IP addresses and the name of the Hosts set in the module and also
allows you to add or remove existing hosts.
● HiPath - shows the current version of the module and allows update to V 5.2, V6.0 or V7.0.
The SLIMC, SADSLIM, LIMC and ADSLIM modules are factory configured to
version 7.0, and may be set to versions 5.2 and 6.0 using the Network -> HiPath tab.