Siemens HiPath 1120 - Page 386

386 Service Manual
Interconnect cables 3-113
Internal entrance telephone 6-223
Issues concerning changes to the default
password 7-280
L
List of modules 3-44
M
Main Configurations 6-208
Main Distribution Frame (MDF) 3-100
Modules 3-43
Overview 3-43
Motherboard (MB) 3-50
HiPath 1120 3-52
HiPath 1150 3-55
N
Numbering Plan 6-205
O
Optional module (MO)
TME1 module 3-69
Optional modules (MO) 3-80
CD 16 module 3-90
Fax/DID module 3-88
S0 module 3-66
UP0/E module and CTR UP0/E module 3-
77
Optional modules(MO) HiPath 1120
Music module 3-91
P
Performing a visual inspection 4-189
Power Supply Unit (PSU) 3-93
Power Systems 2-26
Powering/Protecting the System 4-182
Profiset 3030 System Telephone 5-192
Programming
Digital trunk 6-230
Programming an Extension 6-212
Programming an extension 6-241
Programming comments 6-234
Programming Mode 7-278
Programming mode syntax 7-279
Programming with a computer 7-280
Protection of external lines and extensions 4-
183
Protective power outage relays 4-185
PSU specifications
HiPath 1120 3-94
HiPath 1150/1190 3-95
R
Relay and sensor configuration on the HiPath
1120 6-233
Remote Administration 6-222
Ritto door opener 3-106
Run quick test 6-234
S
S2M Maintenance 7-363
Safety Information 1-18
caution 1-21
warning 1-20
Safety information
danger 1-19
Safety Symbols 1-18
Select the location for installing the equip-
ment 4-127
Size of the HiPath 1190/1190R 4-132
Size of the HiPath1190/1190R 4-132
System cabling 4-186
System Data 2-26
System expansion limitations 2-30
System Telephone Feature Keys 5-203
System telephone settings 5-204
System Telephones 5-191
T
Table of the System’s Programming Codes
6-207
Technical standards and compliance 2-39
Telephones 5-191
TME1 Coax Cable 3-120
TME1 module Connector assignments 3-71
TME1 Serial Cable 3-117